| 1. | The wastewater samples is transmitted by an air-operated aspirator to the liquid injection valve .
用气动吸引器将废水试样送入液体注射阀。 |
| 2. | Liquid injection tool manufacturing
流体喷射器具制造 |
| 3. | Clinical observation for vein liquid injection treatment by compound seven - leave zaoganna sodium gel
复方七叶皂苷钠凝胶治疗静脉输液渗漏的临床观察 |
| 4. | The emission of hc , co of gaseous injection is lowest , intake liquid injection is second , and direct injection is third
气态喷射的hc和co排放量最低、进气道喷射次之，而缸内喷射略高。 |
| 5. | The engine experiment shows that the power output of intake liquid injection or direct injection is not less than . original engine , and its emission is lower
电控液态进气道喷射和缸内喷射在动力性上优于原机，并具有低污染物排放的优点。 |
| 6. | It may be applicable for operation room , icu , liquid injection , lad , medicine making factory and other places as the driving equipment
在血液透分中代替主机血泵：可用于手术室、重症监护室（ icu ） 、输液、实验室和药厂等应用场合作为低流量液体的驱动装置。 |
| 7. | Gas supply system and adjustment principle of replace ratio were introduced in detail and the experimental data was analyzed . the qualification of liquid injection and its merits were also explained in this paper
本文比较详细地介绍了供气系统，也比较详细地对掺烧比调节原理进行了说明，最后对试验进行了分析处理。 |
| 8. | The flame holding technology based on cavity in supersonic combustion was studied systematically and comprehensively . the interaction between gas / liquid injection and cavity flow were studied in non - reaction flows
论文选取基于凹腔的超声速燃烧火焰稳定技术为研究对象,对凹腔燃烧流动过程和凹腔火焰稳定器性能进行了全面深入研究。 |
| 9. | Results indicate that the characteristics of cavity flowfield were altered similarly by gas and liquid injection . the local boundary layer or shear layer are modified by injection on upstream / bottom wall of cavity , and the cavity shear layer immediately becomes angled with respect to the main flow direction . the injection on fore wall of cavity has little effect on the characteristics of cavity flowfield
结果表明:气体/液体喷流对凹腔整体流动特征的影响是一致的,凹腔上游/底壁喷流破坏了当地附面层或剪切层,导致凹腔剪切层偏向主流方向;凹腔前壁喷注对凹腔流场特征基本无影响。 |
| 10. | A lot of photographs of atomization field on high pressure jet were obtained by the use of the energetic liquid injection device and laser holographic system , so that the properties of axial and radial droplets size distribution were revealed . the relations of droplet size distribution with injection pressures , nozzle and viscosity were discussed
利用含能液体喷射雾化模拟装置及其全息摄影系统，得到了多种工况下液体药射流喷雾场的全息照片，揭示了喷雾场中液滴轴向和径向分布规律，分析了喷射压力、喷嘴形状、液体粘度等对射流破碎的影响。 |
